Viair 460C User Manual download pdf (Page 3)

MOUNTING AND WIRING

1. Disconnectgroundcablefromvehicle’sbattery.

2. Temporarily position the air compressor in the location where it will be mounted.

3. Routegroundwiretothenegativepostofthebatteryortoanappropriategroundingpointand

cut ground wire to length as needed.

4. Mountaircompressorwiththefoursetsofbolts,nuts,washers,andlockingwashersprovided.

 (SeeFig.2forMountingInstructions)Useofthreadsealantisrecommended.

5. NOTE:ForRemoteInletAirFilterInstallation,refertoRemoteInletAirFilterInstallation

 InstructionincludedintheRemoteInletAirFilterPack.

6. VIAIRaircompressor(s)comeequippedwithheavydutyheatresistantleaderhose(s)

 with3/8”NPTttings.Thisleaderhoseisdesignedtoprolongthelifeofyourairline.

 Donotremovethisleaderhosefromaircompressor.

7. IMPORTANT:Pleasenote,theleaderhosethatcomeswithyourcompressorhasabuilt-ininline

 checkvalve.DoNotremoveinlinecheckvalvefromleaderhose.

8. Selectproperlocationtomountleaderhosewithhosebracketprovided.Avoidlocationswhere

leader hose may become tangled with wires and other hoses.

9. Tomounthosebracket,drillholewith3/16”drillbitandpushself–anchoringhosebracketpin

 intohole.Routeleaderhosethroughhosebracketandsecurehosebypressingbracketclamp

into locked position.

10.Toremovehosefromthehosebracket,simplypressdownonthehoseclampreleasetabto

 releasebracketclamp.(Fig.3)

11.Connectcompressor’spositiveleadwiretooneoftheleadsofyourpressureswitch.

12.Makesurethatyourcompressorsetupisproperlyfused.Forappropriatefusesize,referto

 ampdrawofcompressorinthespecicationssectionofthismanual.

13.Alwayslocatefuseascloseaspossibletopowersource.

14.Beforeconnectingtopowersource,re-checktomakesurethatallconnectionsare

made properly.

15. Connect and test compressor system by running the compressor for a short time to build up

pressure in your air tank.

16.Onceairpressurereachespresetcutoutpressureofyourpressureswitch,thecompressor

will shut off. Inspect all air line connections for leaks with soap and water solution. If a leak

 isdetected,theairlinemaynotbecutsquarelyorpushedallthewayin.Repairconnections

as needed.

(Fig. 1) 420C / 460C Compressor Installation Parts List:

A. HoseBracket(1pc)

B. MountingBolts(4pcs)

C.FlatWashers(8pcs)

D.LockingWashers(4pcs)

E.Nuts(4pcs)

F.3/8”NPTFx1/2”BarbedFitting(1pc)

G.3/8”NPTMx1/2”BarbedFitting(1pc)

H.RemoteMountFilterAirLine(1pc)

I. AirLineClips(3pcs)

J.Screws(3pcs)

K.RemoteInletAirFilterwithFilterElement(1pc)

USER MANUAL

420C - 460C COMPRESSOR KIT

C E

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Viair 460C User Manual Page 3

Comments to this Manuals

Related products and manuals for For the car Viair 460C