VIAIR 20003 User Manual download pdf (Page 5)

SECTION 1

Under the Hood

1. Remove the BLACK intermediate piece between the front fascia and the

radiator frame, where the hood latch is by removing the 4 bolts on the

radiator frame and 6 clips on the fascia. Set aside and out of the way.

NOTE: PRIMARY FULL TIME AIR HORN SET-UP

If want to install this kit with the purpose of making the air horn your

PRIMARY FULL TIME horn. Perform steps #3 – 6, and 8 (modify this step

such that the red wire need not be inserted any further than the bottom of the

radiator/frame rail, leave the rest of the loom empty till the tubing is brought

into the engine compartment in step #26) then skip to step #26 and complete

the remainder of Section 1.

2. Locate on the firewall, under the hood and on the inside the car, where the

Hood Latch cable penetrates. It’s down below the Brake Master Cylinder

and left of the brake/clutch pedal. This is where we are going to drill a hole,

from the inside, for the wires go to the switch on the dash.

NOTE: IF you have a CAI you need to modify this part of the instructions to

remove your CAI. As need be, that is UNLESS you just want to DEAL WITH IT

further on in the instructions, I highly suggest you remove your CAI.

1 2 3 4 5 6 7 8 9 10 ... 23 24

No comments

VIAIR 20003 User Manual Page 5