120 PSI FAST-FILL AIR SOURCE KIT
USER MANUAL
MOUNTING AND WIRING:
1.Disconnectgroundcablefromvehicle’sbattery.
2. Temporarily position the air source kit in the location
where it will be mounted.
3.Routegroundwiretothenegativepostofthebatteryorto
an appropriate grounding point and cut ground wire to
length as needed.
4.Mountairsourcekitattanklegmountswiththefour
grommets,andfoursetsofbolts,nuts,washers,
andlockingwashersprovided.Useofthreadsealant
is recommended.
5.Route3/8-inchI.D.airlinefromthe1/2-inchtankport
toa3/8-inchcompressionttingandmakeyourairline
connection.Tightencompressionttingnutsecurely
using a wrench.
6.Connectground(Black)wiretoacleanground,(preferablya
chassisground)andsecurewithaself-tappingscrew.
7.Connectpositive(Red)leadwirefrompre-installed
pressureswitchtoafuseholder(25-ampminimum).
8.Oncethekitisproperlyfusedascloseaspossibleto
thepowersource,connectandtestcompressorsystem
by running the compressor for a short time to build up
pressure in your air tank.
9. Once air pressure reaches preset cut out pressure of
yourpressureswitch(90PSIcut-on,120PSIcut-off),the
compressor will shut off automatically. Inspect all air line
connections for leaks with soap and water solution. If a leak
isdetected,theairlinemaynotbecutsquarelyorpushed
all the way in. Tighten connections if needed.
Comments to this Manuals